Routine Maintenace – before you start.
You should visually check the following before use on your Energic motoculteur B5, C7 and D9;
Oil in reservoir 2/3 full (S bloc), grease reservoirs, fan blades, air filter tight, gear selection, inverse directional lever, fuel level, grease on wheel clutches, operation of all levers.
Oil change;
Energic motoculteur oil change using Allen key.
Frequency; every 50 hours of work.The sump plug is found under the engine at the center at the lowest point in the crankcase. To access the plug you approach from under the chassis, where there is a hole just large enough to place upwards a squared holed Allen key (female). The size of the square varied slightly between 8mm and 10mm. I have never retrieved a complete tool kit for the Energic motoculteur B5, C7 and D9 that includes this vital key.
Energic motoculteur sump plug for Allen key
Position der Ölwannenschraube.
Periodically you should totally empty the oil reservoir (for S bloc C7 and D9 only) um den röhrenförmigen Ölfilter aus Gazemetall zum Fallrohr zu reinigen. Das Handbuch sagt “burn off” the offending oil or debris. Caution should be taken here. Use petrol or solvents on the metal filter but you must disconnect the feed pipe to the engine before attempting the cleaning process.
Oil metal gauze filter to inlet pipe feed to the moteur.
View outer cap of the return pipe in the oil reservoir.
Refill the grease cups;
Check the grease cups are full
Refer to the section on “Fan assembly and grease systems”.
Check and clean air filter;
The original air filter element was made from metal and could last a long time with frequent maintenance – see below. Many have been replaced by paper, paper immersed in light oil/colza, sawdust light oil, rags in oil you name it! There is no set frequency for the cleaning of the air filters, it all depends on the conditions in which the machine is working in. Dry dusty conditions need more frequent inspections and cleaning. Die Methode im Handbuch besagt, dass Sie das Metallelement in Benzin eintauchen sollten, bis es sauber ist. Then dry off and place in oil, then drip dry off then place in the outer casing.
Outer view.
Inner view.
further inner view.
Metal air filter dimensions Height 11cms, outer width 10cms and inner width 6.8/7cms. Construction outer and inner surfaces metal mesh with metal rim capped each end. Inner construction metal gauze.
Cleaning in petrol/essence
Das Gehäuse, das die Elemente umgibt, ist vom Lamellentyp, siehe unten, spätere Modelle waren solide mit Löchern im Boden, die mit einer Gaze bedeckt waren, siehe B.
Original outer for air filter.
Second generation outer for air filter with holes at the bottom.
Top/lid for outer for air filter
Viele der ursprünglichen Außengehäuse mit Lamellen litten unter Korrosion und Eindringen von Wasser und wurden durch den späteren Typ ersetzt.
Perished original outer for air filter – water damaged
Water ingress causing corrosion that destroys the outer.
Halten Sie Ihr Energic-Element immer sauber, es wirkt sich wirklich auf die Leistung des Motors aus.
Check the spark plug for carbon/soot, corrosion and spark plug gap.
Early Energic motoculteur models B5, C7 4BL and some D9 5BL models used a smaller diameter (14mm) spark plug or size 10. Such as the new replacement Bosch RO 10 542, UK 10 Champion, or the NGK 3993 BR10EG. the aperture change with the 408 models. (left spark plug option).
The new S Bloc engine, late 1934, used a larger diameter (18mm) spark plug. Wie zum Beispiel die neuen Ersatzteile eines D16 Champion oder eines NGK AB6.
I have seen the spark plug threaded hole, in the cylinder head, re-bored to a larger diameter to fit a D16 champion.
Check the Pont.
Energic motoculteur Pont visual check
Unscrew the inspection hatch and slide aside, view we a torch the condition of the final drive and look at the oil on the cogs. Seal the inspection hatch with a coating of grease after you place it in the closed position. Tighten the wing nuts – seal.
Oil the chain;
Do not let the chain get into this state!
Periodically oil the chain. Kann ohne Demontage des Kettenschutzes durchgeführt werden – If you remove the overflow pipe from the oil tank, then you can drip oil through the hole on top of the chain guard. Rotate the engine manually, making sure that you disconnect the spark plug lead to avoid any hazards.
Energisches Motoculteur-Überlaufölrohr zur Kette vom Vorratsbehälter
Energic motoculteur removal chain gaurd.
Wenn Sie den Kettenschutz abnehmen, haben Sie besseren Zugang zur Kette und zum Kettenspanner, which you also can oil/grease and adjust for the correct tension on the chain.
Energic motoculteur oil/grease the chain tensioner.
See more on the Chain and tensioners page here.
*******
Read more about Energic motoculteur C7 B4L here.
Read more about Energic motoculteur D9 B5L here.
Read more about Energic motoculteur D9 S Bloc here.
Read more about Energic motoculteur C7 S Bloc here.
Read more about Energic History here.
See more on Facebook page: www.facebook.com/energic.info
If you like my Facebook page then I can put more information on it./ Si vous aimez ma page Facebook, je peux mettre plus d’informations à ce sujet.
+