Implements – Ploughs, Buttoir, Cultivateurs, Extirpateur, Bineuse etc.
Find below a selection of the many implements, outils, aanpassingen beschikbaar in het Energic-assortiment, eerst op Motoculteurs geërfd van voor de oorlog op B5, C7, D9 & G9 motoculteurs, to after the war initially in the 400 range then tracteurs from the 500 range. On the ranges of motoculteurs and tracteurs most implements followed these ranges from these dates.
***
******Motoculteurs****** use a vast array of ploughs depending upon the requirement; here are just a few from the 400 and 200 series ranges. Deze waren overal verkrijgbaar 100, 120, 130, 200, 210, 300 ranges in a modified option as well.
De volgende implementaties waren beschikbaar in de Energic motoculteur 400 series beginnend op de 409 van de vroege jaren 1940, then the 410, 411 and 412 modellen en gebruikt gedurende de productiegeschiedenis;
Cultivateurs/Extirpateur
Bineuse
Buttoir
Specialist lifters and cutters
Ploughs
Hitches/Attachments – sulkys
****
De volgende implementaties waren beschikbaar in de rototiller 200/300 serie zotarten op de 220 en gebruikt gedurende de productiegeschiedenis;
Cultivateurs/Extirpateur
Bineuse
Buttoir
Specialist lifters and cutters
Ploughs
Hitches/Attachments – sulkys
*****Tracteurs*****
**********The following attachments where available on the 511 mark 1, 511 mark 2 and 512 diesel serie *********** de vroegste tractor werktuigen
****Winch/Treuil****
Model B from 1953 fitted with a winch/treuil option. (steel cable 100, 150 and 200 meters in length). De lier kan worden bediend op: 6 speeds. It was primary used in the following conditions; when the soil is very heavy (op klei gebaseerd), when cutting the earth was impossible with a pulled plough, when pulling very heavy loads/logs. The winch pulley pulls the cable from the side. It could be fitted with other ancillary equipment modified for specific use. Ook, je zou een haak / bar kunnen bevestigen om te slepen.
****Ploughs/charrues**** Brabant mono soc 1/4 turn versions cylindrical x 2 (25 and 30 cms), version 1/2 helicoidaux (20 cms) and other variations see below.
Energic tracteur 500 series mark 1 and 2 with charrue brabant monosoc + dual side.
Bi-soc No 63 (sur Cadre) gehoekte niet-omkeerbare ploeg. With 2 positions for the blades either normal or décvaillonneur. Also available in many models adapted for the type of agricultural requirement. such as the depth of plough, 25 or 30 cms. Types including Bec de Canard, soc ordinaire. Décavaillonneur for work on plantations, vines, orchards etc.
Tri-soc No 68/ No 63 (sur Cadre) gehoekte niet-omkeerbare ploeg. With 2 positions for the blades either normal or décvaillonneur. Types including Bec de Canard, soc ordinaire. Décavaillonneur for work on plantations, boomgaarden, vines etc.. You can transform the Tri-soc into a bi-soc quite easily.
3 soc/corps mounted on a chassis plough for vine work/viticulture.
****Plough Brabant 1/2 turn/tour****
Brabant 1/2 turn 12 inches, Energic manufactured with regularable width, depth of cut. Het is noodzakelijk om de wielbasis / breedte van de tractor te veranderen om deze grotere ploeg te vergemakkelijken.
Brabants 1/4 turn are available in 25 cms and 30 cms plough depth forms in cylindriques. Brabants are also available in 1/4 turn 25 cms and 30 cms plough depth forms in Hélicoidaux (soc rocheux). Upon demand they can be bought in allonges de versoirs, bec de canard, rasettes, pleine soc, porte socs etc.
****Buttoir****
Left to right; Buttoir No 26 and No 55. Voor het inline planten van gewassen, row crops, potatoes etc.
****Hoes/Bineuse on Chassis No 43****
Hoe 5 socs on a chassis No 43. Chassis nummer 43 consists of a frame in the shape of a V, which is variable in width depending upon the use. Normal with 5 or 7 dents or long with 9 dents. It also can be used as a Cultivateur with 5, 7 or 9 dents that are semi-rigid. Of een Expirpateur hetzelfde met stijve deuken. In the form of a Bineuse it would have 3 or 5 socs in normal form and 7 socs in lange vorm. The wheels can be altered to height or removed.From left to right Bineuse 5 soc, Bineuse 5 soc, Bineuse No 31 (3 or 5 dents), cultivateur 7 dents and cultivateur 5 dents. Photo above with tracteur – cultivateur 7 dents.
****Cultivateurs/Extirpateur No 42****
Left photo; Cultivateur No 45 with 5 or 7 dents, semi-flexibel direct op het chassis gemonteerd. Either 150 mm, 175 mm or 200 mm curve. Right Extirpateur No 42, 5 or 7 dents. The dents are rigid on the Extirpateur.
****Hay/grass cutters****
Beschikbaar als achteraf achter een dynabloc of de aftakas. It was regulable for height and angle. With 3 cutting positions on the blade for course to a fine cut and for different crops; available in Normale, Danoise and Intermediate.
De bovenkant is de Normale snit, het midden de Intermediaire en de onderkant de Danoise gesneden. The distance between the digits being 75 mm, 50 mm and 37.5 mm respectively.
De messen waren eenvoudig te vervangen voor onderhoud of in geval van breuk / vervanging. The cutter/barre de coupe blade being 1.37 m in width. Een optie zou op alle Energic tracteur kunnen worden gemonteerd 500 series.
Here is the cutting bar/ barre de coupe adapted to a Reaper/Moissonner, with extensions, seat and “rateau”.
****Specialties****
Potatoe lifters, trekkers/Potato Snatcher.
****Spraying system/Pulvérisateur****
Maximum capacity of 200 litres, for the treatment of trees, shrubs, vines, fruit trees in all forms of agriculture large to small. The sprayer operates from 0 to 40 kg/cm2 pressure (3 pistons). This can be regulated depending upon the usage, treatment and product. Het wordt direct bediend vanaf de aftakas/prise de force en kan tot maximaal worden doorgespoten 3 lances.
****Rear PTO output****
The PTO/prise de force can operate a pulley wheel of various diameters from 110 mm, 150 mm, 180 mm, to 210 mm. This system can operate external large equipment like combines/moissonneuse, manure distributors/ epandeur de fumier, cutting bars/barre de coupe etc. It can be operated through 6 speeds/gears and is operated stationary for pumps, saws, dorsmachines enz. Dit aftakaspoeliesysteem wordt bevestigd door 6 screws and can easily be placed or detached.
****Cultivateur****
The left photo shows a smaller rear only positioned cultivateur that can be lifted when not in use. The other 9 or 10 dents with supporting wheels.For working on plantations or and full/only soil. The whole width of the tracteur is worked. Operated at slower speeds in plantations.
Rear lifts options;
****Rear lifts options*****
Type A Dynabloc automatic. Low maintenance, lifting capacity of 250 kgs, De PTO / Prize de force komt uit de achterkant van het Dynabloc-systeem wanneer hij uit de weg wordt getild. You can either tow from the chap/crochet on the dynabloc or the bar de outils. Dit systeem kan worden gemonteerd op een smalle breedte van 511/2 as shown in the photo above. (Attelage type S)
Type B manual lift. Operated with a lever system pulling through gears and ratchet a cable to raise the towing hook for the ploughs etc.
U kunt de werktuigen / uitrustingsstukken direct achter de tractor trekken of ze in een hoek zetten die past bij het type landbouw, wijnbouw waarin u actief was.
Type C hydraulic lift/revelage hydraulique. Using a 3 puntensysteem - werkend door de oliedruk door het Dynabloc, that can be infinitely variable for height and pressure.
U kunt de werktuigen / uitrustingsstukken direct achter de tractor trekken of ze in een hoek zetten die past bij het type landbouw, wijnbouw waarin u actief was.
Type C hydraulic lift/revelage hydraulique. Using a 3 puntensysteem - werkend door de oliedruk door het Dynabloc, that can be infinitely variable for height and pressure.
****Mounting adaptions****
Treuil, Faucheuse, Pulverisateur and Dynabloc. Door middel van een kraan of blok en takel hijsen en omkeren van de tractor in positie voor het monteren van de aanpassingen / uitsteeksels.
****Towing/Remorquage****
**********
Read more about the Energic factory history here.
Read more about the Energic motoculteur 224 here.
Read more about the Energic motoculteur 409 here.
Read more about the Energic Motoculteur 410 here.
Read more about the Energic motoculteur 412 here.
See more on Facebook page: www.facebook.com/energic.info
If you like my Facebook page then I can put more information on it./ Si vous aimez ma page Facebook, je peux mettre plus d’informations à ce sujet.